close
close

How To Add An Electrical Outlet From A Light Switch

th 480

How To Add An Electrical Outlet From A Light Switch. Remove the wall plate and and screws that hold the switch in place. The circuit wires required for an outlet include a ground wire, a neutral wire and the circuit power wire.

I WANT TO ADD AN ELECTRICAL OUTLET BETWEEN A LIGHT AND A
I WANT TO ADD AN ELECTRICAL OUTLET BETWEEN A LIGHT AND A from www.justanswer.com

If you know which breaker in your electrical panel serves that circuit, then switch it off. Simply insert the end of the tester into an outlet, lamp socket, or hold the end of the tester against the wire you wish to test. Turn the power back on and make sure that the outlet works properly by plugging in a lamp and checking to see that the light switch turns the lamp on and off.

To Connect The Switches, Simply Score The Wire With Your Wire Stripper And Push The Insulation To Expose About 3/4 In.

In the drywall near your switch, cut a hole that will fit your electrical box, and fasten the box. Now you can see that to attempt to add an outlet or a receptacle from this switch box will not work in this. Connect the load side of the switch to a terminal of the socket.

Then Connect Line Neutral To The Other Terminal Of The Outlet.

Remove the wall plate and and screws that hold the switch in place. When remodeling an older home or adding an addition, you may want to add extra electrical outlets. The neutral to the receptacle goes with the other white wires.

Simply Insert The End Of The Tester Into An Outlet, Lamp Socket, Or Hold The End Of The Tester Against The Wire You Wish To Test.

With all switches and receptacles, connect the circuit's ground wire (bare copper or with green insulation) to the device's ground screw. This is probably something more geared toward a garage or workshop setup, since it would serve better purposes there. Connect the last switch in the usual manner, looping the wire around the screw in a clockwise direction.

Adding An Outlet To A.

One terminal of the switch is connected to the hot wire of the power supply. Very handy and easy to use. Turn the power back on and make sure that the outlet works properly by plugging in a lamp and checking to see that the light switch turns the lamp on and off.

Turn Off The Correct Circuit At Your Electrical Panel.

Attach that to the chrome screw on the switch outlet combo and attach the live black wire to the brass terminal. To add an outlet to a light switch, you start by making a pigtail using the hot wire, the wire going to the fixture controlled by the switch and a third length of wire. Pull out the switch, and locate the black, white, and bare electrical wires and the terminals they're connected to.

Leave a Reply

Your email address will not be published.